Injection of Recombinant Tissue Plasminogen Activator into Extracorporeal Membrane Oxygenators Postpones Oxygenator Exchange in COVID-19.

Coronavirus disease 2019 (COVID-19) has drastically increased the number of patients requiring extracorporeal life support. We investigate the efficacy and safety of low-dose recombinant tissue-type plasminogen activator (rtPA) injection into exhausted oxygenators to delay exchange in critically ill COVID-19 patients on veno-venous extracorporeal membrane oxygenation (V-V ECMO). Small doses of rtPA were injected directly into the draining section of a V-V ECMO circuit. We compared transmembrane pressure gradient, pump head efficiency, membrane arterial partial oxygen pressure, and membrane arterial partial carbon dioxide pressure before and after the procedure. Bleeding was compared with a matched control group of 20 COVID-19 patients on V-V ECMO receiving standard anticoagulation. Four patients received 16 oxygenator instillations with rtPA at 5, 10, or 20 mg per dose. Administration of rtPA significantly reduced transmembrane pressure gradient (Δ pm = 54.8 ± 18.1 mmHg before vs . 38.3 ± 13.3 mmHg after, p < 0.001) in a dose-dependent manner (Pearson's R -0.63, p = 0.023), allowing to delay oxygenator exchange, thus reducing the overall number of consumed oxygenators. rtPA increased blood flow efficiency η (1.20 ± 0.28 ml/revolution before vs . 1.24 ± 0.27 ml/r, p = 0.002). Lysis did not affect membrane blood gases or systemic coagulation. Minor bleeding occurred in 2 of 4 patients (50%) receiving oxygenator lysis as well as 19 of 20 control patients (95%). Lysis of ECMO oxygenators effectively delays oxygenator exchange, if exchange is indicated by an increase in transmembrane pressure gradient. Application of lysis did not result in higher bleeding incidences compared with anticoagulated patients on V-V ECMO for COVID-19.

Lean Ad hoc Extracorporeal Membrane Oxygenation Systems for COVID-19.

Coronavirus disease (COVID-19) is overwhelming hospitals with patients requiring respiratory support, including ventilators and Extracorporeal Membrane Oxygenation (ECMO). Bottlenecks in device availability may contribute to mortality, and limited device availability even in ECMO centers has led to rationing recommendations. Therefore, we explored options for ad hoc construction of venovenous ECMO using readily available components, essentially, large cannulas, membrane oxygenators, and blood pumps. As thousands of certified cardiac Impella pumps are distributed worldwide, we assembled lean ECMO by embedding Impella pumps coaxially in tubes, combined with standard gas exchangers. Ad hoc integration of Impella blood pumps with gas exchange modules, large-bore venous cannulas, regular ECMO tubing, Y-pieces, and connectors led to lean ECMO systems with stable performance over several days. Oxygenation of 2.5-5 L of blood per minute is realistic. Benefit/risk analysis appears favorable if a patient needs respiratory support but required support systems in a center are exhausted. Ad hoc assembly of venovenous ECMO is feasible using Impella blood pumps, results in stable blood flow across gas exchange modules, and thus may offer another opportunity to oxygenate, "recover the lungs" and hopefully save lives in selected patients with severe COVID-19 disease even when conventional life support equipment is exhausted. The lean design also yields inspirations for future ECMO systems.

Continuous venous hemodialysis integrated to the ECMO circuit in critically ill patient with COVID-19, a case report in Morocco.

Novel coronavirus 2019 (COVID-19) is a severe respiratory infection leading to acute respiratory distress syndrome [ARDS] accounting for thousands of cases and deaths across the world. Several alternatives in treatment options have been assessed and used in this patient population. However, when mechanical ventilation and prone positioning are unsuccessful, venovenous extracorporeal membrane oxygenation [VV-ECMO] may be used. We present a case of a 62-year-old female, diabetic, admitted to the intensive care unit with fever, flu-like symptoms and a positive COVID-19 test. Ultimately, she worsened on mechanical ventilation and prone positioning and required VV-ECMO. The use of VV-ECMO in COVID-19 infected patients is still controversial. While some studies have shown a high mortality rate despite aggressive treatment, such as in our case, the lack of large sample size studies and treatment alternatives places healthcare providers against a wall without options in patients with severe refractory ARDS due to COVID-19.

Artificial lungs--Where are we going with the lung replacement therapy?

Lung transplantation may be a final destination therapy in lung failure, but limited donor organ availability creates a need for alternative management, including artificial lung technology. This invited review discusses ongoing developments and future research pathways for respiratory assist devices and tissue engineering to treat advanced and refractory lung disease. An overview is also given on the aftermath of the coronavirus disease 2019 pandemic and lessons learned as the world comes out of this situation. The first order of business in the future of lung support is solving the problems with existing mechanical devices. Interestingly, challenges identified during the early days of development persist today. These challenges include device-related infection, bleeding, thrombosis, cost, and patient quality of life. The main approaches of the future directions are to repair, restore, replace, or regenerate the lungs. Engineering improvements to hollow fiber membrane gas exchangers are enabling longer term wearable systems and can be used to bridge lung failure patients to transplantation. Progress in the development of microchannel-based devices has provided the concept of biomimetic devices that may even enable intracorporeal implantation. Tissue engineering and cell-based technologies have provided the concept of bioartificial lungs with properties similar to the native organ. Recent progress in artificial lung technologies includes continued advances in both engineering and biology. The final goal is to achieve a truly implantable and durable artificial lung that is applicable to destination therapy.

A Simple Approach for Gas Blender on Extracorporeal Membrane Oxygenation in Resource Shortage Context.

With the massive influx of patients during COVID-19 pandemic into intensive care unit, resources have quickly been stretched to the limit, including extracorporeal membrane oxygenation (ECMO). Gas blender attached to ECMO is used to allow precise adjustment of characteristics of fresh gas flow, that is, blood oxygen delivery and carbon dioxide removal. To cope with the gas blender shortage, we describe a back-up system set up in our French tertiary referral ECMO center using air and oxygen flowmeters. A table has been created to facilitate medical prescription but also nurse monitoring. This extraordinary situation forces physicians to adapt medical devices, and that could be useful in future viral pandemics.

Extracorporeal Blood Purification and Organ Support in the Critically Ill Patient during COVID-19 Pandemic: Expert Review and Recommendation.

Critically ill COVID-19 patients are generally admitted to the ICU for respiratory insufficiency which can evolve into a multiple-organ dysfunction syndrome requiring extracorporeal organ support. Ongoing advances in technology and science and progress in information technology support the development of integrated multi-organ support platforms for personalized treatment according to the changing needs of the patient. Based on pathophysiological derangements observed in COVID-19 patients, a rationale emerges for sequential extracorporeal therapies designed to remove inflammatory mediators and support different organ systems. In the absence of vaccines or direct therapy for COVID-19, extracorporeal therapies could represent an option to prevent organ failure and improve survival. The enormous demand in care for COVID-19 patients requires an immediate response from the scientific community. Thus, a detailed review of the available technology is provided by experts followed by a series of recommendation based on current experience and opinions, while waiting for generation of robust evidence from trials.